Table of Contents
Advertisement
RT6084 - SINGLE DK MSD600
• Balanced digital only, providing 4 AES
input pairs per card, wired to female
D25 connectors on the console's rear
interface.
• Unbalanced digital and balanced
analogue mixed, providing 2 analogue
inputs and 1 AES3id input pair per
card. Analogue inputs are wired to
female D25's, digital to BNC's, both on
the console rear interface.
• Balanced digital and balanced
analogue mixed, providing 2 analogue
inputs and one AES input pair per card,
wired to female D25 connectors on the
console's rear interface.
• Analogue only, providing 8 balanced
analogue inputs per card, wired to a
female D25 connector on the rear
console's interface.
The input card types required affect the
internal wiring of the control surface and
should be specified at the time of order.
Hydra2outputprovision
No audio is fed to 3rd party meters by
default. If such meters are to be fed from
console meter selectors, and/or console
DSP outputs, provision needs to be made
in the quantity of Hydra2 outputs being
ordered with the console.
Resets
Three reset buttons along with an enable
button are located in the centre of this
panel.
CALREC
Putting Sound in the Picture
++
RT6082 - SINGLE RTW TM7
As a safety precaution, to activate a reset,
the enable button must also be pressed
as well as the desired reset button.
The resets are split into three areas -
• 'DSP' resets the audio signal
processing cards in the processing
core.
• 'Control' resets the Master Control
processors (the console's overall
controller) in the processing core.
• 'Surface' resets the control surface
panels.
More than one reset can be pressed at
the same time if required. Each area
can be independently reset and will
automatically re-sync with the rest of the
system on reboot.
It is not possible to reset the router from
the control surface. Router reset buttons
are only available on the processing
core. This is a safety precaution, on a
networked system, other users may be
accessing I/O via any given router card.
Talkbackmic
A female XLR is provided on this panel
to connect the supplied goose-neck
microphone. This connects directly to an
XLR on the rear interface panel (no gain
or power is applied in the console).
RT6089 - NO METERS FITTED
RT6191 - SINGLE DK T7
ARTEMIS
RESET
RESET
RESET
ENABLED
TB MIC
DSP
SURFACE
CONTROL
ENABLE
The microphone can be connected into an
external talkback system, or the console's
own talkback system via a Hydra2 input.
Please refer to the console configuration
section for details on console talkback
setup.
USBport
The USB port on this panel connects
directly to a USB port on the console
PC, providing convenient access for file
transfer, such as memory backups.
The spare USB-Ethernet adaptor can
also be connected to this USB port to
provide a temporary additional network
connection to the PC if the rear interface
panel is not as convenient to access.
USB
107
Advertisement
Table of Contents
