Audio Performance Specification - Calrec Artemis Installation And Technical Manual

Digital broadcast production console
Hide thumbs Also See for Artemis:
Table of Contents

Advertisement

AUDIO PERFORMANCE SPECIFICATION

HYDRA2 AES3ID UNBALANCED DIGITAL INPUTS
Format
Interface, Input Sensitivity
Sample Rate Conversion
SRC THD+N
HYDRA2 AES3ID UNBALANCED DIGITAL OUTPUTS
Format
Interface
Jitter
HYDRA2 AES3 BALANCED DIGITAL INPUTS (MODULAR I/O ONLY)
Format
Interface, Input Sensitivity
Sample Rate Conversion
SRC THD+N
HYDRA2 AES3 BALANCED DIGITAL OUTPUTS (MODULAR I/O ONLY)
Format
Interface
Jitter
HYDRA2 ANALOGUE INPUT SPECS
Analogue - Digital
Conversion
Input
Input Impedance
Sensitivity
Equivalent Input Noise
Distortion
Frequency Response
Input CMR
(Common Mode Rejection)
Crosstalk
Notes
CALREC
Putting Sound in the Picture
AES/EBU (AES3) 24-bit. Also suitable for use with SPDIF (IEC958 type 2) signals
75 Ohm unbalanced (BNC), 0.3V–1.2V Pk-Pk
24-Bit switchable on all AES inputs, SRC Range 30kHz to 100kHz
-117dB @ 1kHz, 0.00014%
AES/EBU (AES3) 24-bit
75 Ohm unbalanced 1V Pk–Pk (nominal) into 75 Ohm load (BNC)
<0.015UI (2.5ns) peak
AES/EBU (AES3) 24-bit.
110 Ohm balanced (XLR or D-Type). 0.2V-7.0V Pk-Pk
24-Bit switchable on all AES inputs, SRC Range 30kHz to 100kHz
-117dB @ 1kHz, 0.00014%
AES/EBU (AES3) 24-bit
110 Ohm balanced (XLR or D-Type)
<0.015UI (2.5ns) peak
24 Bit
Electronically Balanced
2k Ohms at mic level gain settings
10k Ohms at line level gain settings
+18 / -78dB for Mic/Line Inputs
-127dB (150 Ohm source)
-1dBFS @ 1kHz — Better than 0.003%
-20dBFS @ 1kHz — Better than 0.006%
-60dBFS @ 1kHz — Better than 0.3%
20Hz to 20kHz +/- 0.5dB on Mic/Line Inputs
>75dB (Typical 85dB) on Mic/Line inputs
-105dB or better on adjacent channels with 0dBFS tone at 1kHZ on Source
Analogue input for 0dBFS can be pre-set globally to +28, +24, +22, +20, +18 or +15dBU
Pre-fader headroom on mic inputs is adjustable globally from +24dB to +36dB in 2dB steps
For analogue inputs/outputs the system can handle analogue levels of up to +27 dBu from
analogue input to analogue output at line up
These levels must be attenuated in the system before they are fed to digital outputs
121

Advertisement

Table of Contents
loading

Table of Contents