Fader Panel - Ic5791 - Calrec Artemis Installation And Technical Manual

FADER PANEL - IC5791

The IC5791 Fader panels make up the
majority of an Artemis control bed,
multiple panels being fitted across the
control bed to make up the required
quantity of faders.
The IC5791 is fitted with 8 x 100mm
throw faders. The upper half of the panel
works in conjunction with an up-stand
TFT display that should be fitted directly
above the fader panel in order to gain
full access to assignable panel controls
such as EQ, routing, output control etc,
however it can be used as a fader panel
without an associated TFT screen.
As standard, the panel is fitted with
'Cut' buttons to mute fader paths.
As an option, 'On' buttons can be fitted
and the software configured for reverse
functionality - the fader path is active
when On is lit and muted when it is not.
If On buttons are required, this should be
specified at the time of order.
Connections
This panel has a single RJ45 POE
connection for its data and power.
Fader panels connect to specific POE
switches / ports, as defined by the
surface layout configuration set in the
Main Application.
A (NOT*) DVI connector is used to send /
receive data from the associated up-stand
TFT screen above the fader panel, if fitted.
*Note, the connector type is DVI, but the
format is not DVI - This should not be
connected to anything other than Calrec
TFT panels, doing so may damage the
equipment.
Mouse and TFT VGA connections
(internal) are used for factory
configuration only.
102 ARTEMIS
Digital Broadcast Production Console
CUT CUT CUT
AFL AFL AFL
ISO ISO ISO
DIR DIR DIR
TB TB TB
PFL PFL PFL
CONNECTOR LAYOUT
CTRL SYSTEM MOUSE
CUT CUT CUT CUT
AFL AFL AFL AFL
ISO ISO ISO ISO
DIR DIR DIR DIR
TB TB TB TB
PFL PFL PFL PFL
IC5791 Serial No.
CUT
AFL
ISO
DIR
TB
PFL
TFT METER (NOT DVI)
Panel Options