Configuring The Device; Adapting The Default Module Selection For Bioimpedance Analysis; Showing/Hiding Default Module Selection - Seca 514 Administrator's Manual

6. CONFIGURING THE DEVICE

6.1 Adapting the default module selection for bioimpedance analysis

Showing/hiding default module
28 •
The default module selection determines which evaluation modules are
considered during a bioimpedance analysis.
The device is factory-set so that when the
module selection
vated. This way, the module selection can be verified before each measure-
ment and, if necessary, adapted to suit the individual measurement.
The device can be configured in such a way that the
dialog window does not appear if the
an in-house default module selection.
In order to determine whether or not the
window is displayed before each bioimpedance analysis, proceed as outlined
selection
below.
1. Press the
The secondary menu is displayed.
2. Press the
The
User
The current setting is displayed (button appears gray = pressed).
3. Press the desired setting.
–
–
4. Press the
The module selection is saved and will be available from the next
bioimpedance analysis.
dialog window appears and all evaluation modules are acti-
button.
menu changeover
button.
settings
menu appears.
: default module selection is active. It is displayed before every
no
bioimpedance analysis and can be adapted to suit the measure-
ment in question.
: default module selection is active but is not displayed before
yes
the bioimpedance analysis. The default module selection can only
be adapted in the
settings
button.
apply
tab is activated, the
bia
Default module selection
tab is activated. You can also create
bia
Default module selection
menu.
Default
dialog