Table of Contents
Advertisement
It will be necessary to clean the glass periodically. During startup, condensation, which is normal, forms on the inside of the glass, and
causes dust, lint etc. to cling to the glass surface.
Also, initial paint curing can deposit a slight film on the glass. It is therefore recommended that initially the glass be cleaned two or three
Cautions and Warnings
times with a commercial fireplace glass cleaner. After that, the glass should be cleaned two or three times a season depending on the
circumstances.
· Do not clean when the glass is hot.
· The use of substitute glass will void all product warranties (see
· Care must be taken to avoid breakage of the glass.
· Do not operate this fireplace without the glass front or with a broken glass front.
· Do not strike or abuse the glass.
!
Only Robax ceramic or coated Neoceram glass may be used for replacement for Models
Glass must be minimum 5mm thick.
To replace glass, clean all materials from the door frame. Scrape off old silicone all the way down to the metal. Using high-temp silicone
[rated up to 500°F (260°C)] apply a continuous bead of approximately 1/8"-3/16" to all four [4] sides of the frame. With the frame resting
on a flat surface, insert the new glass with a new gasket. Gently press the glass into the silicone. Be careful not to use excessive force
on the glass. Let the silicone dry for approximately 15-20minutes.
Use caution when removing broken glass. Wear gloves.
NOTE: A Door Latch Tool is provided to assist with removing and installing the glass doors. See next page.
1.
Remove the door by unlatching the 2 top latches. Simply place 2 fingers in the grooves, and pull and lift upward slightly.
2.
Once the top of the door is unlatched, tilt the door forward and lift upward to release the bottom.
3.
When re-installing the door, place the bottom of the door into the door retainer slot and then secure the door with the top latches.
*Over time, the door latch spring (Part#36HB-123) may need to be replaced if tension is lost.
1.
To replace latch spring, remove the 2 hex screws (located in the firebox) that secure the latch assembly in place.
2.
Once the screws are removed the latches will slide out of place.
3.
Remove the locknut from the latch assembly and replace the spring. Re-tighten the locknut until 2 thread turns are beyond the
locknut. This is critical for proper tension. Replace latch assembly.
Latch Assembly
51MQ-123A
in this section).
,
and
.
57
- Quick Links:
- Framing Your Gas Fireplace
Hide quick links:
Advertisement
Table of Contents
