Marquis MQRB4436N Installation Instructions Manual page 43

Before installing any mantels it is important to determine the combustibility of its
material(s). There are two types of mantels to consider: Combustible and Non-
Combustible.
A
combust, or lose its integrity in the presence of heat. These types of mantels
must strictly conform to the dimensional requirements shown below.
Conversely, a
that will not combust. Check your local codes and regulations to determine whether your mantel is Combustible or Non-Combustible.
The advantage to Non-Combustible Mantels is that it may extend right up to the tile lip of the fireplace. Combustible mantels must
adhere to the dimensional restrictions shown below.
Front
Back Shield Kit to Wall
Side (from Stand-offs)
Floor*
Airbox on Flue Side of Unit
Minimum Ceiling Height (from bottom of fireplace)
Top (from Stand-offs)
Top of 90° Bend under 78" Enclosure
Top of 90° Bend over 78" Enclosure
Top of Horizontal Pipe
Side & Bottom of Horizontal Pipe
Vertical Vent Pipe
Vertical Vent Pipe
* If appliance is installed directly on carpeting or other combustible material other than wood flooring, a metal or
wood panel extending the full width and depth of the appliance must be used. Carpet may extend 1 inch above the
floor of the appliance.
is one that consists of material(s) that may discolor,
is one that is constructed with material(s)
[Steel Stud Framing Shown.]
Mantel Dimensions are from
front face or Non-Combustible
Facing Materials covering
fireplace.
Combustible objects must not be placed
on a Non-combustible Mantel unless the
mantel meets the dimensional
requirements for a Combustible Mantel.
Refer below to determine whether your
mantel conforms to the requirements of
a Combustible Mantel.
24"[61cm]
0" [0cm]
0" [0cm]
0" [0cm]
1" [25cm]
64" [Vertical Venting]
68"[Horizontal Venting-See MQRB6961
Combustible Enclosure Heights page]
0" [0cm]
6-1/2" (With Wall Thimble Shield
[Z57WTS]) All Vent Systems
6-1/2" All Vent Systems
2" All Vent Systems
1" All Vent Systems
1" All Vent Systems
1" DuraVent-DirectVent Pro /
AmeriVent / Selkirk Direct Temp
Systems
43