Door And Glass Information - Marquis MQHBZDV3636 Instruction Manual

Glass Cleaning
It will be necessary to clean the glass periodically. During start-
up, condensation, which is normal, forms on the inside of the
glass and causes dust, lint etc. to cling to the glass surface.
Also, initial paint curing can deposit a slight film on the glass.
It is therefore recommended that initially the glass be cleaned
two or three times with non-abrasive common household glass
cleansers and warm water. After that, the glass should be
cleaned two or three times a season depending on the circum-
stances.
Cautions and Warnings
• Do not clean when the glass is hot.
• The use of substitute glass will void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Do not operate this fireplace without the glass front or with a
broken glass front.
• Do not strike or abuse glass.
Glass Replacement
REPLACEMENT GLASS FOR BOTH DIRECT VENT UNITS
Model Series MQHBZDV4736 use Low E
Tempered Glass. Must be 5mm thick.
Only Robax ceramic or coated Neaoceram
glass may be used for replacement for
model MQHBZDV3636, MQHBZDV4236
and MQRB4236. Must be minimum 5mm
thick.
To replace glass, clean all materials from
door frame. Scrape off old silicone down to
metal. Using a high heat silicone tempera-
ture-resistant to 500°F (260°C) apply a
continuous bead of approximately 1/32" to
all four sides of frame and insert glass with
new gasket. Frame should be on flat sur-
face, with a small amount of weight press-
ing glass into silicone. Let dry approximate-
ly 15 to 20 minutes. The door can be re-
installed by reversing Steps 1 & 2. Use
caution when removing broken glass, wear
gloves.
Appliance/Log Reference Chart/Log Placement
The following is a list of models and appropriate log sets that can be used with each model. It is important that the appropriate
log set is used with the correct model in order for the appliance to work properly.
MQHBZDV3636N or LP
MQHBZDV4236N or LP
MQHBZDV4736N or LP

Door and Glass Information

Appliance LOGF36 MQROCK1
✔
✔
✔
Removal of the Glass Door
1. Remove the door by unlatching the 2 top latches. Simply
place 2 fingers in the grooves, pull towards you and lift
upwards slightly.
2. Once the top of the door is unlatched, simply pull outwards
and lift upwards to unlatch the bottom.
3. When re-installing the door place the bottom of the door in
first and secure with Top Latch assembly to the door.
Spring Replacement:
*Over time, spring may need to be replaced if tension is lost.
1. To remove the top latch, remove the 2 hex screws that secure
it in place. They are located in the firebox.
2. Once all the screws are removed the latches will slide out of
place.
3. There is 1 lock nut per latch. When replacing a spring, tight-
en the lock nut until 2 threads are beyond the locknut. This is
critical for proper tension.
MQRSP1 MQRSP2
MQROCK1
✔
✔
✔
38