Marquis MQRB4436N Installation Instructions Manual page 69

: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
The Valve Assembly may be changed to the other side of the fireplace.
This must be done
Remove the Burner Tube (See
!
this Manual).
Disconnect plumbing from the
valve, including connections to
Pilot. Remove the [4] DT screws in
the burner pan which hold the
Valve System in place. Reinstall
with the Valve System on the other
side of the fireplace. Note that as
stated in , the millivolt valve
system can be transferred to the
right side without rotation, while the
for proper operation on the
right side of the unit.
Take care not to damage the
pilot tube during this operation.
:Wires and plumbing must
not interfere with explosion damper
assembly.
Reconnect plumbing, along with Pilot.
Remove the Electrical Box and
Light Power Bus Module (and IPI
Module & IPI Shield if used), and
locate these items to the other side
of the unit.
Refer to & below.
Replace the Burner Tube.
Fig.3 Right Hand Millivolt Valve
the unit is inside the enclosure.
Fig.1
section in
Fig.2
Fig.4 Right Hand IPI Valve
69