Juniper EX9200 Features Manual page 125

Table 8: show interfaces Fast Ethernet Output Fields (continued)
Field Name Field Description
Total number of ingress queues supported on the specified interface. Displayed
Ingress queues
on IQ2 interfaces.
Queue counters CoS queue number and its associated user-configured forwarding class name.
(Ingress) Displayed on IQ2 interfaces.
Queued packets
Transmitted packets
Dropped packets
Active alarms and Ethernet-specific defects that can prevent the interface from passing packets.
When a defect persists for a certain amount of time, it is promoted to an alarm.
Active defects
Based on the routing device configuration, an alarm can ring the red or yellow
alarm bell on the routing device, or turn on the red or yellow alarm LED on the
craft interface. These fields can contain the value
None
Link
unplugged, the far-end system has been turned off, or the PIC is
malfunctioning.
The forward error correction (FEC) counters provide the following statistics:.
OTN FEC statistics
Corrected Errors
Corrected Error Ratio
example, 1e-7 is 1 error per 10 million bits.
PCS statistics (10-Gigabit Ethernet interfaces) Displays Physical Coding Sublayer (PCS) fault
conditions from the WAN PHY or the LAN PHY device.
Bit errors
(BER) occurred while the PCS receiver is operating in normal mode.
Errored blocks
occurred while the PCS receiver is operating in normal mode.
Copyright © 2016, Juniper Networks, Inc.
—Number of queued packets.
—Number of transmitted packets.
—Number of packets dropped by the ASIC's RED mechanism.
—There are no active defects or alarms.
—Interface has lost its link state, which usually means that the cable is
—The count of corrected errors in the last second.
—The corrected error ratio in the last 25 seconds. For
—The number of seconds during which at least one bit error rate
—The number of seconds when at least one errored block
Chapter 8: Operational Commands
or .
None Link
Level of Output
extensive
extensive
detail extensive none
detail extensive
109