Table of Contents
Advertisement
Fan Filter Tray Servicing
Figure 45.
Fan Tray Removal
Fan Tray Replacement
1. Guide the fan tray into a fan tray slot at the VMG-14+ chassis until it is firmly seated.
2. Using a 0.250-in slotted screw driver, tighten the lower captive screws on the Fan Tray faceplate.
3. At the Fan Tray LED, check to ensure that the OK LED is illuminated.
Fan Filter Tray Servicing
The Fan Filter tray should be checked periodically to rule out excess dust collection. A dirty air filter can
cause overheating of the system. Imagine Communications recommends that air filters be replaced
every three to six months, or more often (as dependent on conditions in the operations site).
To view the location of the Fan Filter Tray, see
Fan Filter Removal
Remove the air filter by grasping both handles on the air filter tray, and sliding it out and away from
the air filter slot.
Fan Filter Replacement
Grasping the handles of the Fan Filter Tray, carefully align and insert the new Fan Filter into its slot at
the front of the VMG-14+ chassis.
Selenio
TM
VMG-14+ Hardware Setup Guide
Be very careful!!!
Do not place your hand anywhere
near a moving fan.
Captive screws
"Fan Filter Tray" on page
Gen2 Release 1.4.0
22.
65
Advertisement
Chapters
Table of Contents
