Electrostatic Discharge (Esd) Prevention; Unpacking And Inspection; Figure 25: Location Of Esd Jack - Imagine communications Selenio VMG-14+ Hardware Setup Manual

Electrostatic Discharge (ESD) Prevention

AC‐Power Cord
International AC power cords will be supplied (or recommended), as needed, to ensure that AC power
connectivity is compliant with power requirements for your operations site.
Note: The VMG-14+ requires AC input 240 VAC.
Electrostatic Discharge (ESD) Prevention
To prevent ESD damage during installation or removal of Selenio VMG modules, wear an ESD ground
strap, and connect it to the ESD terminal at either the front or the rear of the chassis
Figure 25. Location of ESD Jack
ESD ground jack
at front of any
VMG-14+ chassis.
Unpacking and Inspection
Begin inspection as soon as your Selenio VMG shipment arrives. If you see damage (such as punctures,
damp spots, or crushed corners) anywhere on the shipping carton, do not proceed with the unpacking
instruction in this chapter. Immediately notify the transfer company about the damage, and record the
damage on the bill of lading.
Store the Selenio VMG in its original packaging until it is needed for installation.
Once you begin to unpack, do not discard any of the packing materials until you have completed the
unpacking procedures and verified the integrity of your Selenio VMG shipment. You may need to reuse
the materials if returning the product to Imagine Communications.
Caution: When opening the shipping carton, use caution to avoid damaging the Selenio VMG.
Selenio TM VMG-14+ Hardware Setup Guide
ESD ground jack
at rear of AC
chassis.
Gen2 Release 1.4.0
(Figure 25).
ESD ground jack
at rear of DC
chassis.

39