Video Processor Module; Figure 14: Vpm Front Panel; Table 11: Vpm Front Panel Leds - Imagine communications Selenio VMG-14+ Hardware Setup Manual

VMG-14+ System Modules
Video Processor Module
The VPM (Figure
"VPM LEDs" on page
•
Figure 14. VPM Front Panel
Statu Fault Reset
Hot Backup
Swap
Config
VPM LEDs
The VMP faceplate provides the LEDs list in
Table 11. VPM Front Panel LEDs
LED Name
Hot Swap
Status
Config
Fault
Backup
Selenio TM VMG-14+ Hardware Setup Guide
14) provides the indicators described in the following section:
27.
Color/Condition
Blue
Flashing Blue
Off
Red
Green
Red
Green
Orange
Red
Green
Red
Green
Table 11.
Description
VPM is ready for hot-swap.
VPM is making transition from hot-swap not ready to ready state,
or from ready state to hot-swap not-ready state.
VPM is not ready for hot-swap.
Chassis interface fault.
Payload up.
FPGA configuration in progress.
FPGA configuration completed.
FPGA failure: reverting to factory defaults.
Fault.
Normal operation.
Standby.
In operation.
Gen2 Release 1.4.0
27