Transcoding Modules; Figure 15: Tcm, Tcm2, Tcm2+ Front Panel; Table 12: Tcm, Tcm2, Tcm2+ Front Panel Leds - Imagine communications Selenio VMG-14+ Hardware Setup Manual

VMG-14+ System Modules
Transcoding Modules
The family of transcoding modules includes the TCM, TCM2, and TCM2+, which share common
characteristics at their faceplates
"TCM, TCM2, TCM2+ LEDs," on this page.
Figure 15. TCM, TCM2, TCM2+ Front Panel
Status Fault
Hot
Backup
Swap
Config
For TCM usage in the VMG-14+, the TCM must be compatible with the installed NPM or NPM2:
Use TCM only with NPM (GEN1 VMG).
•
Use TCM2 or TCM2+ only with NPM2 (GEN2 VMG).
•
TCM, TCM2, TCM2+ LEDs
The TCM, TCM2, TCM2+ faceplate provides the LEDs listed in
Table 12. TCM, TCM2, TCM2+ Front Panel LEDs
LED Name
Hot Swap
Status
Config
Fault
Backup
SDI Monitoring Port
LED
Selenio TM VMG-14+ Hardware Setup Guide
(Figure 15) and provides the indicators and functions described in
Reset
Color/Condition
Blue
Flashing Blue
Off
Red Chassis interface fault.
Green
Red
Green
Red
Green
Red Standby.
Green
n/a
Table
Description
TCM is ready for hot-swap.
TCM is making transition from hot-swap not-ready to ready state,
or from ready state to hot-swap not-ready state.
TCM is not ready for hot-swap.
Payload up.
FPGA configuration in progress.
FPGA configuration completed.
Fault.
Normal operation.
In operation.
This LED is currently not used.
Gen2 Release 1.4.0
SDI Monitoring Port
LED
Reset
SDI Monitoring Port 
(not currently in
use)
12.
28