Application Media Processor; Figure 16: Amp Module Front Panel; Table 13: Amp Front Panel Leds - Imagine communications Selenio VMG-14+ Hardware Setup Manual

VMG-14+ System Modules
Application Media Processor
The AMP (Figure
sections:
"AMP Interfaces" on page
•
"AMP LEDs" on page
•
Figure 16. AMP Module Front Panel.
For AMP usage in the VMG-14+, one AMP module is always paired with an NPM, using the following
rules:
The AMP in slot 3 must be paired with the NPM in slot 1.
•
The AMP in slot 4 must be paired with the NPM in slot 2.
•
Note: If you are using AMP Cards, you must install the same number of AMP cards as NPM cards. A
configuration such as two NPMs and one AMP, or one NPM and two AMPs is not supported.
Note: If you are not using AMP Cards, you do not need AMP modules and can install TCM and VPM
modules in slots 3 and 4 instead. If you previously used AMP modules and are now using TCM
and/or VPM modules in those slots instead, you must power cycle the VMG in order for those
modules to come up.
AMP Interfaces
The AMP module interfaces with an NPM via direct connectivity between the ETH ports of the AMP to
the SFP GigE ports on the NPM. Each AMP must be paired to an NPM, using guidelines provided in
"AMP-to-NPM Cabling" on page
AMP LEDs
Table 13 describes the AMP front panel LEDs.
Table 13. AMP Front Panel LEDs
LED Name
OOS (Out of
Service)
Health
Selenio TM VMG-14+ Hardware Setup Guide
16) provides the interface, indicators and functions described in the following
29.
29.
ETH 1 ETH 2
OOS Health
49.
Color/Condition
Red
Off
Solid green
Flashing green
Off
Serial 1
USB ports
Description
System out of service.
System normal.
AMP firmware is active, payload enabled.
AMP firmware is active, payload disabled.
AMP firmware is inactive.
Gen2 Release 1.4.0
Reset
Hot Swap
29