Figure 41: Global Configuration - Management Interface Tab - Imagine communications Selenio VMG-14+ Hardware Setup Manual

Using Element Manager to Finalize Initial Configuration
5. In the System tab, enter the value for (minimally) one NTP server address and the Time Zone.
6. Optionally, enter the Syslog Server IP Address and Port number (the typically UDP port for syslog
is 514).
7. Click on the Management Interface tab
(management) IP address of the system. The IP address configured here will be used to access the
VMG-14+.
Figure 41.
8. In the Virtual IP Address section, enter the IP Address, Subnet Mask (netmask), and Gateway
(default router) address (if used).
9. Click Apply (or use Alt a) button to commit the values and complete initial configuration.
Note: For instructions on configuring the VMG-14+ with the Element Manager, refer to the Selenio
VMG-14+ Element Manager User Guide.
Selenio TM VMG-14+ Hardware Setup Guide
Global Configuration - Management Interface Tab
(Figure 41) to access configuration fields for the virtual
Gen2 Release 1.4.0
TM
59