Amp-To-Npm Cabling; Figure 35: Amp Connections To An Npm Or Npm2 Pair In The Vmg-14 - Imagine communications Selenio VMG-14+ Hardware Setup Manual

Installation Instructions
AMP‐to‐NPM Cabling
Note: The AMP-to-NPM cabling described in this section applies only to VMG-14+ system loaded with
a pair of VMG GEN 1 NPM cards.
Once the AMP card is installed, use the cable Ethernet cable provided by Imagine Communications to
connect the AMP card to its corresponding NPM card:
Connect the AMP card in slot 3 to the NPM in slot 1.
•
Connect the AMP card in slot 4 to the NPM in slot 2.
•
Connect the Ethernet cable to ETH 1 on the AMP and GigE port 8 on the NPM.
•
Connect the Ethernet cable to ETH 2 on the AMP and GigE port 7 on the NPM.
•
Figure 35 shows the front panel connections for a 2-NPM or NPM2 /2-AMP configuration at the
Selenio VMG.
Figure 35. AMP Connections to an NPM or NPM2 Pair in the VMG-14+
Selenio TM VMG-14+ Hardware Setup Guide
Additional information about AMP setup is
available in the Application Media Processor
(AMP Installation Guide for VMG Systems (part
number 250-0104-01).
Gen2 Release 1.4.0
49