Ethernet Link Object - Hirschmann MACH 100 User Manual

EtherNet/IP
2.2.3

Ethernet Link Object

The Switch supports at least one instance (Instance 1; the instance of the
CPU Ethernet interface) of the Ethernet Link Object (Class Code F6
of EtherNet/IP.
Id Attribute
1 Interface Speed Get
2 Interface Flags Get
3 Physical
Address
4 Interface
Counters
5 Media Counters Get
6 Interface
Control
7 Interface Type Get
Table 5: Ethernet Link-Objekt
24
Access Data type
rule
UDINT
DWORD
Get ARRAY of 6
USINTs
Get Struct MIB II
Counters
Jeweils UDINT
Struct Ethernet
MIB Counters
Jeweils UDINT
Get/Set Struct Control
Bits WORD
Forced Iface
Speed UINT
USINT
2.2 EtherNet/IP Parameters
Description
Used interface speed in MBits/s (10, 100,
1000, ...). 0 is used when the speed has not
been determined or is invalid because of
detected problems.
Interface Status Flags:
Bit 0: Link State (1: Link up),
Bit 1: 0: Half-Duplex, 1: FullDuplex1,
Bits 2 through 4: Autoneg Status (0: Autoneg
in Progress, 1: Autoneg unsuccessful,
2: unsuccessful but Speed detected,
3: Autoneg success, 4: No Autoneg),
Bit 5: manual configuration requires reset
(always 0 because not needed),
Bit 6: detected hardware error.
MAC address of physical interface.
InOctets, InUcastPackets, InNUcastPackets,
InDiscards, InErrors, InUnknownProtos,
OutOctets, OutUcastPackets,
OutNUcastPackets, OutDiscards, OutErrors.
Alignment Errors, FCS Errors, Single
Collision, Multiple Collision, SQE Test Errors,
Deferred Transmissions, Late Collisions,
Excessive Collisions, MAC TX Errors, Carrier
Sense Errors, Frame Too Long, MAC RX
Errors.
Control Bits:
Bit 0: Autoneg enable/disable (1: enable),
Bit 1: Duplex mode (1: full duplex, if Autoneg
is disabled).
Interface speed in MBits/s: 10, 100,..., if
Autoneg is disabled.
Value 0: Unknown interface type,
Value 1: The interface is internal,
Value 2: Twisted-pair,
Value 3: Optical fiber.
, 246)
H
UM IndustProtocol
Release 9.0 02/2015