Hirschmann MACH 100 User Manual page 25

EtherNet/IP
Id Attribute
8 Interface State Get
9 Admin State
10 Interface Label Get
Table 5: Ethernet Link-Objekt
The Switch supports additional vendor specific attributes.
Id Attribute
100 Ethernet
(64 Interface Index
H)
101 Port Control
(65
H)
102 Interface
(66 Utilization
H)
103 Interface
(67 Utilization
H) Alarm Upper
Threshold
104 Interface
(68 Utilization
H) Alarm Lower
Threshold
Table 6: Hirschmann-Erweiterungen des Ethernet Link-Objekts
UM IndustProtocol
Release 9.0 02/2015
Access Data type
rule
USINT
Set USINT
SHORT_
STRING
Access Data type
rule
Get UDINT
Get/Set DWORD
Get UDINT
Get/Set UDINT
Get/Set UDINT
2.2 EtherNet/IP Parameters
Description
Value 0: Unknown interface state,
Value 1: The interface is enabled,
Value 2: The interface is disabled,
Value 3: The interface is testing,
Value 1: Enable the interface,
Value 2: Disable the interface.
Interface name. The content of the string is
vendor-specific.
Description
Interface/Port Index (ifIndex from MIB II)
Bit 0 (RO): Link state (0: link down, 1: link up)
Bit 1 (R/W): Link admin state (0: disabled,
1: enabled)
Bit 8 (RO:) Access violation alarm
Bit 9 (RO): Utilization alarm
The existing Counter from the private MIB
hmIfaceUtilization is used. Utilization in
a
percentage . RX Interface Utilization.
Within this parameter the variable
hmIfaceUtilizationAlarmUpperThreshold can
be accessed.
Utilization in percentage
Utilization Upper Limit.
Within this parameter the variable
hmIfaceUtilizationAlarmLowerThreshold can
be accessed.
Utilization in percentage
Utilization Lower Limit.
a
. RX Interface
a
. RX Interface
25