Hirschmann MACH 100 User Manual page 18

EtherNet/IP
Configuration of a PLC using the example of Rockwell

software
 Open the "EDS Hardware Installation Tool" of RSLinx.
 Use the "EDS Hardware Installation Tool" to add the EDS file.
 Restart the "RSLinx" service so that RSLinx takes over the EDS file of
the Switch.
 Use RSLinx to check whether RSLinx has detected the Switch.
 Open your Logix 5000 project.
 Integrate the Switch into the Ethernet port of the controller as a new
module (Generic Ethernet Module).
Setting
Comm Format:
IP Address
Input Assembly Instance
Input Size
Output Assembly Instance
Output Size
Configuration Assembly Instance 3
Configuration Size
Table 2: Settings for integrating a Generic Ethernet Module
18
2.1 Integration into a Control System
I/O connection Input only
Data - DINT Data - DINT
IP address of the IP address of the
Switch Switch
2 2
7 7
(MACH 4000: 11) (MACH 4000: 11)
1 254
1 0
(MACH 4000: 2)
3
0 0
Listen only
Input data - DINT -
Run/Program
IP address of the
Switch
2
7
(MACH 4000: 11)
255
0
3
0
UM IndustProtocol
Release 9.0 02/2015