Tcp/Ip Interface Object - Hirschmann MACH 100 User Manual

EtherNet/IP
2.2.2

TCP/IP Interface Object

The Switch supports an instance (instance 1) of the TCP/IP Interface Object
(Class Code F5
H
In the case of write access, the Switch stores the complete configuration in
its flash memory. Saving can take 10 seconds. If the save process is
interrupted, for example, by a power cut, the Switch may become inoperable.
Note: The Switch replies to the configuration change "Set Request" with a
"Response" although saving of the configuration has not yet been completed.
Id Attribute
1 Status
2 Interface
Capability flags
3 Config Control Set/Get
4 Physical Link
Object
Table 4: TCP/IP Interface Object
22
, 245) of EtherNet/IP.
Access Data type
rule
Get DWORD
Get DWORD
DWORD
Get Structure: UINT
Path size
EPATH Path
2.2 EtherNet/IP Parameters
Description
Interface Status (0: Interface not configured,
1: Interface contains valid config).
Bit 0: BOOTP Client,
Bit 1: DNS Client,
Bit 2: DHCP Client,
Bit 3: DHCP-DNS Update,
Bit 4: Configuration settable (within CIP).
Other bits reserved (0).
Bits 0 through 3:
Value 0: using stored config,
Value 1: using BOOTP,
Value 2: using DHCP.
Bit 4: 1 device uses DNS for name lookup
(always 0 because not supported)
Other bits reserved (0).
Path to the Physical Link Objekt, always {20H,
F6H, 24H, 01H} describing instance 1 of the
Ethernet Link Object.
UM IndustProtocol
Release 9.0 02/2015