HPE FlexNetwork MSR Series Comware 7 Layer 3 - Ip Services Configuration Manuals page 188

NAT internal server information:
Totally 1 internal servers.
Interface: GigabitEthernet2/0/2
Protocol: 17(UDP)
Global IP/port: 202.38.1.4/53
Local IP/port : 200.1.1.3/53
Config status : Active
NAT logging:
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw : Disabled
Alarm
NAT mapping behavior:
Mapping mode : Address and Port-Dependent
ACL : ---
Config status: Active
NAT ALG:
DNS : Enabled
FTP : Enabled
H323 : Disabled
ICMP-ERROR : Enabled
ILS : Disabled
MGCP : Disabled
NBT : Disabled
PPTP : Enabled
RTSP : Enabled
RSH : Disabled
SCCP : Disabled
SIP : Disabled
SQLNET : Disabled
TFTP : Disabled
XDMCP : Disabled
Static NAT load balancing:
# Display NAT session information generated when Host accesses the Web server.
[Router] display nat session verbose
Slot 1:
Initiator:
Source IP/port: 192.168.1.2/1694
Destination IP/port: 202.38.1.2/8080
DS-Lite tunnel peer: -
VPN instance/VLAN ID/Inline ID: -/-/-
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
Disabled
174