The Leds - GE Advisor MASTER ATS111 series Manager Manual

8
ATS Control Panel
Manager's manual
In some instances there can be insufficient space to display all the text being presented (for example, a list of
areas in your building):
•
If a complete list is displayed on line 1, there is a full stop at the end of the list.
•
If the list is incomplete, there is a ">" at the end of the line and the full stop does not appear. By
pressing [NEXT], you can then display the rest of the list and update the information at the same
time.
•
If only part of a name or location is shown, it can be moved left by entering the applicable
number preceding the text, and then pressing [ENTER].
Your system might display a custom message instead of the one shown above if it has been programmed to do
so, for example:

The LEDs

The red LED Advisor MASTER on the Advisor MASTER keypad, together with the information shown on
the display, allows you to determine the system status at a glance. Not all LEDs are available on all arming
stations.
Area LEDs
The area LEDs, one for each of the possible security areas, indicate the status of the particular area.
ON The area is unoccupied and armed.
OFF The area is occupied and the security system has been set to allow normal access.
BLINKING An alarm has occurred in the area while the area was disarmed (LED flashes slow) or armed (LED flashes
fast).
System alarm LEDs (available on some arming stations only)
The system alarm LEDs indicate a breach of security. One of the system alarm LEDs flashes when an alarm
has occurred (the area's armed LED also flashes to indicate the location of the alarm).
DISARMED alarm
24-HOUR alarm
ARMED alarm
TAMPER alarm
System faults (available on some arming stations only)
System faults are displayed on the arming station keypads if the arming station has an LCD fitted and/or
"System faults" LEDs.
There Are No Alarms In This Area
Code:
Welcome to the ATS
Code:
Flashes when an alarm has occurred in an occupied area and the area was disarmed.
Flashes when an alarm has occurred in an area where a zone has been programmed for 24-hour
alarm.
Flashes when an alarm has occurred in an armed area.
Flashes when an alarm has occurred due to tamper.