22
ATS Control Panel
Manager's manual
What to do when there is an alarm
When there is an alarm, the LED of the area in alarm and the alarm LED flashes on the keypad. If the screen
saver is active, the LEDs will start flashing when a user code has been entered). The time and date message is
no longer displayed.
An area can have several zones associated with it. When there is an alarm, it is important that you know
exactly which zone is causing the problem so that you can quickly deal with it.
In case of an alarm in a system set up for voice reporting, the system may indicate "Stop Voice Reporting on
disarming the area". Press ENTER to accept.
Resetting a local alarm
•
The keypad emits a discontinuous tone until the local alarm is acknowledged (if programmed).
•
The LED of the area in alarm flashes red on the keypad, depending on how it has been
programmed (if the screen saver is not active).
•
The display shows the following:
To reset a local alarm
1. Press [ENTER] twice.
2. The zones causing the alarm are listed either:
You now know which zones are causing the problem.
3. From either display:
Option
Acknowledge the local
alarm
Display the zone name in
full
Update the list of zones
4. The display shows:
5. Fix the problem (for example, close the door).
Re-alarming: if your system has been programmed to remind you about alarms, it will automatically re-alarm after a preset
time unless the cause has been fixed, no matter how many times you acknowledge the alarm.
Local Alarm
Code:
One at a time
or
As
a
list
of
numbers
Action
Press 0 and [ENTER]
Press [NEXT]
Enter the zone number
and press [ENTER]
There Are No Alarms In This Area
Code:
Example:
Local Alarm On A4. Rear Fire Door
NEXT or ENTER
Example:
Local Alarm On A4, A5, A9, NEXT
Zone No:
Result
Acknowledge the local alarm (see below). Depending on programming
a user code is required to reset.
Display the complete zone name.
Update the list of zones and display the next zones in the list (if any).