Door Opening Option - GE Advisor MASTER ATS111 series Manager Manual

Door opening option

An Advisor MASTER keypad, Card Reader or combination of both can be used to open a door by entering a
door code or badging a card.
Your door code is related to your PIN code. It varies, depending on whether your PIN code has been
programmed to allow you to arm/disarm your system, as well as open doors.
To open a door with PIN code
1. The bottom line of the display must show:
2. Enter your door code (see Note 3 below).
3. Press:
•
[ENTER] to open the door only, or
•
[OFF] to disarm the security and open the door if your full PIN code is entered (see Notes 2 and
3 below), or
•
[ON] to arm the security and open the door if your full PIN code is entered (see Notes 2 and 3
below).
To open a door with card
1. When using a keypad with build in card reader, the bottom line of the display must show:
2. Badge your card to open the door only, or
•
2a. Badge your card to disarm the security system and open the door, or
•
2b. Badge your card 3 times to open the door and arm the security system.
If the door can only be opened for a preset time, the display might show:
If the door is closed before the end of the maximum open time, the word "Shunted zone" is removed from the
display and the keypad sounds the warning buzzer for three seconds to indicate that the door is no longer
shunted.
If the door is not closed at the end of the shunt time, the display shows "Shunting Ends" on the top line of the
display.
The keypad sounds the warning buzzer for a preset time to let you close the door or re-enter your PIN code to
extend the shunt time.
1. If the keypad sounds seven quick beeps when you enter your door code, an invalid code has been entered, or the code is
not valid at this arming station.
2. A door code only opens doors that are programmed to be opened by that code. I.e. the Door Group assigned to the user
might not allow access to all doors.
Code:
Code:
Shunted zone
Code:
13