GE Advisor MASTER ATS111 series Manager Manual page 52

52
ATS Control Panel
Manager's manual
reader (or keypad with reader) as being the Card Learn RAS. Cards being badged at that RAS will be stored in
a History log. When programming users, this historical list can be used to assign a card number to a user.
To learn this card information, the card has to be badged on the learn reader. Once the card number is learned,
it can be connected to any user.
13. In case the special memory mode is selected, the display shows:
Either badge a new card to connect to this user, or press [Menu*] to select a card that has been badged earlier
on the "Card Learn Reader" and is in History. The 1
latest card. A maximum of 10 cards can be remembered in history. Once the card is badged or selected from
History, the display shows the following:
View the number of users
1. Access menu option 14 and press 4 to view the number of a user already programmed.
The display shows:
Example:
2. Press [ENTER] to exit.
Select a Card Learn RAS
1. Access menu option 14 and press 5 to select a RAS as Card Learn RAS.
The display shows:
Example:
2. Enter a valid RAS number (reader) to use as Card Learn RAS. Ask your installer, what numbers are
available in your system.
3. Press [ENTER] to exit.
1. You cannot create a user unless you have access to Menu 14 (Users)
2. You cannot assign an alarm group to a user unless your alarm group has at least the same rights.
3. You cannot program a PIN code or user number that already exists.
4. You cannot program a PIN code that will conflict with another user duress code (refer to the section on Duress).
5. You cannot program a PIN code that will conflict with another user door code (refer to the section on Opening a Door).
Waiting for Card:
*-Hist
Card Bits: 27.0.0.4.210.0.2
*-Del
Total Users 2
Press ENTER
1
Card RAS:
st
number is the earliest card. The last number will be the