GE Advisor MASTER ATS111 series Manager Manual page 50

50
ATS Control Panel
Manager's manual
7. If your system is programmed to assign special user flags to the users, the display now shows them in
sequence.
Table 2: The user flags:
Two Cards
Guard
Visitor
Trace User
Card Only
Privileged
Extended Access
The display shows:
Example:
Do one of the following options:
Option
Change YES to NO, or NO to YES, and display the new setting
Save the displayed setting and move to the next User Flag
Save the displayed setting; skip the remaining user flags,
and move on to the next step
The programming procedure detailed above is the same for all the user flags.
The display shows:
Example:
Example:
Example:
If set to YES, the user will always require a second valid user code/card to be entered to perform any
alarm or access control function at Doors 17 to 64.
If set to YES, the user's code/card can only perform functions at Doors 17 to 64 when used in conjunction
with a "Visitor" code/card.
If set to YES, the user's code/card can only perform functions at Doors 17 to 64 when used in conjunction
with a "Guard" code/card.
If set to YES, all alarm and access functions performed by the user at Doors 17 to 64, will cause a "Trace"
message to be sent to the management computer.
If set to YES, the user will NOT be able to use the PIN code. This allows the PIN code field to be used to
program cards on formats not normally compatible with the control panel, when a special reader is
used.
If set to YES, the User's code/card will over-ride any "Anti-Passback" restrictions on Doors 17 to 64.
If set to YES, the user will be allowed extended door access times at Doors 17 to 64.
For example, To allow the door to remain open longer for disabled access.
YES - Two Cards
* - Change 0 - Skip
YES - Guard
* - Change 0 - Skip
YES – Visitor
* - Change 0 - Skip
YES – Trace User
* - Change 0 - Skip
Action
Press [MENU*]
Press [ENTER]
Press 0