GE Advisor MASTER ATS111 series Manager Manual page 46

46
ATS Control Panel
Manager's manual
•
The control panel user (or card) number. This is a number between 1 and 65535 depending on the
memory size (see exceptions below), which is used by the system to link a PIN code or card to
the functions it will perform and the doors it can enter.
When programming cards, the ID number programmed in the card is the user number.
Exceptions:
1. Your system has card offset.
2. Your system has a special memory mode (IUM-Intelligent User Module).
•
The user alarm group, which determines the user areas and alarm control functions, for example,
Manager, Staff etc.
•
The users door group, which determines which doors the user has access to.
•
The users floor group, which determines which floors the user has access to.
•
The user name (some users only).
•
The user PIN code (some users only). Note that card ID numbers are NOT programmed as the
PIN code.
Only 50 users with name, PIN code and/or card can be programmed in a system with standard memory.
In a system with an expanded memory:
•
•
•
•
To enter the User menu
1. Press [MENU*].
The display shows:
2. Enter your PIN code and press [ENTER].
The display shows:
3. Enter 14 and press [ENTER].
The display shows:
When the special memory mode is used, the display shows:
Your own alarm group might not allow you to program PIN codes. If it does allow use of the function, there
might still be restrictions on which alarm groups you are allowed to update.
Only the first 200 users can have their name programmed to their user number.
Only the first 1000 users can have a PIN code assigned to them.
Users 1 to 1000 can have a PIN code and/or card.
Users 1001 to 65535 can only have a card.
To Access Menu Enter Code
Code:
0-Exit ENTER-Down
0-Exit, Menu:
1-Delete 2-Display 3-Create
Option:
*-Up