Internal Trap Installation Only - Zoeller 105 Installation Instructions Manual

STEP 4
4.1) Cut the tailpipe to the dimension determined in Figure 4.1.
4.2) Install the sink drain components to the lid as shown in Figure 4.2.
4.3) Orient the lid assembly as shown in Figure 4.3 and secure the trap components.
(HAND TIGHTEN the assembly to the lid at this time. Adjustment will be required in Step 5.)
Note: To ensure a proper water seal, the extension must be installed as shown in the "trap detail".
INTERNAL TRAP COMPONENTS SUPPLIED BY OTHERS.
X
TAILPIPE
LENGTH
115 mm
Figure 4.1
TAIL PIPE
DISCHARGE
Figure 4.3

Internal Trap Installation Only

DIMENSION MEASURED
IN STEP 1.
TRAP DISCHARGE PARTIALLY
VISIBLE THROUGH THE CORD
SEAL OPENING.
CORD SEAL OPENING
VENT
© Copyright 2017 Zoeller
TAIL PIPE
INLET
TRAP
Figure 4.2
Co. All rights reserved.
®
6
TRAP DETAIL
102 mm
FLANGED TAIL PIPE
(SEE NOTE)
SK2004