Helpful Hints For Easy Installation; Do’s And Don't’s For Installing A Unit; Performance Characteristics - Zoeller 105 Installation Instructions Manual

1. Read all instructions before beginning installation.
2. Be certain that basin is on a firm level surface.
3. Do not use an automatic plumbing vent device.
4. Do not over-torque lid attachment screws.
5. Always use a check valve on the discharge line.
6. Test operation of pump per STEP 6 on page 7.
1. DO read all installation material included with the pump.
2. DO inspect unit for any visible damage caused by shipping.
Contact dealer if unit appears to be damaged.
3. DO clean all debris from the basin and pump.
4. DO always disconnect pump from power source before
handling. DO always connect to a separately protected and
properly grounded ground fault protected circuit. DO NOT
ever cut, splice or damage power cord. DO NOT carry or lift
pump by its power cord. DO NOT use an extension cord.
PUMP PERFORMANCE CURVE
20
6
15
4
10
2
5
0
GALLONS
LITERS
0
Ten Helpful Hints For Easy Installation
Do's And Don't's For Installing A Unit

Performance Characteristics

MODEL 53
10 20 30 40
80 160
FLOW PER MINUTE
© Copyright 2017 Zoeller
7. Always provide some means to disconnect basin from
plumbing for maintenance purposes.
8. Run unit at least once a month to verify proper operation.
9. The model number and date code can be found on the lid
warning label.
10. Plug pump into a properly grounded GFCI receptacle.
5. DO NOT use a discharge pipe smaller than the pump dis-
charge size.
6. DO test pump immediately after installation to be sure that
the system is working properly.
7. DO review all applicable local and national codes and verify
that the installation conforms to each of them.
8. DO NOT install unit in the ground.
TOTAL DYNAMIC HEAD/FLOW
EFFLUENT AND DEWATERING
MODEL
Feet
5
10
15
Shut-off Head:
009897
50
Co. All rights reserved.
®
3
PER MINUTE
53
Meters Gal. Liters
1.5 43 163
3.0 34 129
4.6 19 72
19.25 ft.(5.9m)