Advertisement
ZoellerAtHome.com
Zoeller
is a registered trademark of
®
Zoeller Co. All Rights Reserved.
ATTACH YOUR RECEIPT HERE
Serial Number
Questions, problems, missing parts? Before returning to your retailer, call our customer service
department at 1-800-584-8089, 7:30 a.m. - 5:00 p.m., EST, Monday - Friday.
CONVERTIBLE JET PUMP
IL0345
Purchase Date
© 2020. All rights reserved.
INSTRUCTIONS
FOR DEEP WELL
INSTALLATION
1
CAST IRON
MODEL #1463-0006
(25-70 FT.)
024990 C
Advertisement
Table of Contents
Related Manuals for Zoeller 1463-0006
Summary of Contents for Zoeller 1463-0006
- Page 1 CAST IRON CONVERTIBLE JET PUMP ZoellerAtHome.com MODEL #1463-0006 Zoeller is a registered trademark of ® Zoeller Co. All Rights Reserved. INSTRUCTIONS FOR DEEP WELL INSTALLATION (25-70 FT.) IL0345 ATTACH YOUR RECEIPT HERE Purchase Date Serial Number Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-584-8089, 7:30 a.m.
-
Page 2: Product Specifications
ITEM # HP VOLTAGE HZ ROTOR DEEP WELL AMPS flammable and/or explosive atmospheres. AMPS 30 FT 40 FT 50 FT 60 FT 70 FT 1463-0006 115/230 14/7 52/26 10.6 CAUTION • PRODUCT DAMAGE MAY RESULT This pump is not to be used for irrigation or water systems. -
Page 3: General Pump Information
PREPARATION Typical Pump Setup Discharge Before beginning installation of product, make sure all parts are present. If any part is missing or damaged, do to Home 1-1/4 in. Suction 3/4 in. not attempt to assemble the product. Compare parts to package contents list. Discharge Pipe 1. - Page 4 3. All piping from the well to the pump should slope PUMP TO PRESSURE TANK CONNECTION (DISCHARGE PIPE) - DEEP WELL slightly upward with no sagging. Support suction 1. To begin the connection to the pressure tank, Unions pipe between water source and pump. Unions in Suction install the 1 in x 3/4 in adapter (included) to pump Flow Control...
- Page 5 4. Install a 3/4 in. union (optional) and continue 5. Continue with fittings and pipe to the pressure with pipe and 3/4 in. x 3/4 in. x 3/4 in. tee. tank. A 3/4 in. union is optional but recommended for easy connection and disconnection. CAUTION: Install a pressure relief valve on any installation where the pump pressure can exceed Glue...
- Page 6 PUMP ELECTRICAL CONNECTIONS 2. Insert an electrical wire strain relief into the opening in the side of the pressure switch closest to the motor. WARNING: WIRING DIAGRAM Check Voltage of Power Source • Always disconnect pump from electricity before Before Connecting 115 Volts 230 Volts performing any work on the motor.
- Page 7 starwatersystems.com UL Std. No. 778 ENCLOSURE 3 JHU10 Pump: Rev: 98U1071 Motor: 6. Insert an electrical wire strain relief into the To change from 230 V to 115 V opening in the opposite side of the pressure Wire from Volts 115/230 S.F.
- Page 8 PUMP PRIMING & STARTUP - DEEP WELL 5. If pump is correctly primed, pressure will quickly build and register on the gauge mounted on the CAUTION: All pumps must be primed (filling pump body. If pressure does not build, repeat the cavity with water) before they are first operated.
-
Page 9: Care And Maintenance
CARE AND MAINTENANCE QUICK TROUBLE-SHOOTING CHECKLIST Winterizing Please review the following troubleshooting questions before returning a pump as defective. If you have any questions, please call Customer Service at (800) 584-8089. PREVENT CAUTION: Drain the entire system if there is 1. -
Page 10: Troubleshooting
TROUBLESHOOTING WARRANTY This product is warranted for two years from the date of purchase. Subject to the conditions hereinafter set PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION forth, the manufacturer will repair or replace to the original consumer any portion of the product which proves Little or no 1.
Need help?
Do you have a question about the 1463-0006 and is the answer not in the manual?
Questions and answers