Table of Contents
Advertisement
Manufacturer warrants, to the purchaser and subsequent owner during
the warranty period, every new product to be free from defects in material
and workmanship under normal use and service, when properly used
and maintained, for a period of one year from date of purchase by the
end user, or 18 months from date of original manufacture of the product,
whichever comes first. Parts that fail within the warranty period, one
year from date of purchase by the end user, or 18 months from the
date of original manufacture of the product, whichever comes first,
that inspections determine to be defective in material or workmanship,
will be repaired, replaced or remanufactured at Manufacturer's option,
provided however, that by so doing we will not be obligated to replace
an entire assembly, the entire mechanism or the complete unit. No
allowance will be made for shipping charges, damages, labor or other
charges that may occur due to product failure, repair or replacement.
This warranty does not apply to and there shall be no warranty for any
material or product that has been disassembled without prior approval
of Manufacturer, subjected to misuse, misapplication, neglect, alteration,
accident or act of nature; that has not been installed, operated or
maintained in accordance with Manufacturer's installation instructions;
that has been exposed to outside substances including but not limited
to the following: sand, gravel, cement, mud, tar, hydrocarbons,
hydrocarbon derivatives (oil, gasoline, solvents, etc.), or other abrasive
or corrosive substances, wash towels or feminine sanitary products,
1. Inspect your unit. Occasionally, products are damaged
during shipment. If the unit is damaged, contact your dealer before
using.
2. Carefully read the literature provided to familiarize yourself
with specific details regarding installation and use. These
materials should be retained for future reference.
3.
Do not lift, carry, or hang pump by the
electrical cables. Damage to the electrical cables can
cause shock, burns or death.
4.
Make sure the pump electrical supply
circuit is equipped with fuses or circuit breakers of proper
capacity. A separate branch circuit is recommended, and
sized according to the "National Electrical Code" for the current
shown on the pump nameplate.
5.
Pump is designed to pump cold ground water
that is free of air or gases. Decreased pump performance and life
expectancy can occur if the ground water is not cold (86 ºF/30 ºC)
or contains air or gases.
LIMITED WARRANTY
etc. in all applications. The warranty set out in the paragraph above
is in lieu of all other warranties expressed or implied; and we do not
authorize any representative or other person to assume for us any
other liability in connection with our products.
Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky
40211, Attention: Customer Support Department to obtain any needed
repair or replacement of part(s) or additional information pertaining
to our warranty.
MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR
SPECIAL, CONSEQUENTIAL OR INCIDENTAL DAMAGES OR
BREACH OF EXPRESSED OR IMPLIED WARRANTY; AND
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR
PURPOSE AND OF MERCHANTABILITY SHALL BE LIMITED TO
THE DURATION OF THE EXPRESSED WARRANTY.
Some states do not allow limitations on the duration of an implied
warranty, so the above limitation may not apply to you. Some states
do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
This warranty gives you specific legal rights and you may also have
other rights which vary from state to state.
PREINSTALLATION INFORMATION
6.
7.
8.
9.
© Copyright 2015 Zoeller
Co. All rights reserved.
®
2
DO NOT run the pump dry. DO NOT run the pump
with a completely closed discharge. DO NOT pump chemical or
corrosive liquids. Failure to follow above warnings could result in
damage to the pump, voiding the warranty and causing personal
injury.
Check to be sure your power source is capable
CAUTION
of handling the voltage requirements of the motor, as indicated on
the pump nameplate.
Water hammer creates momentary high pressure
CAUTION
surges. These surges can cause severe damage to check valves
and the piping system. Consideration for water hammer must be
included in the piping system design. Reference ASPE Data Book,
Chapter 2.33. Some systems may require external spring or lever
weighted check valves or other engineered solutions.
Prop65 Warning for California residents: Cancer
and Reproductive Harm- www.P65warnings.ca.gov.
Advertisement
Table of Contents
