STEP 1
NOTE: The basin is designed to be installed directly under the sink (Internal Trap) or on the side (standard).
IMPORTANT!
Check local and state codes before using the internal trap option.
1.1) Figure 1.1A and 1.1B are typical configurations for installation of the drain systems. The actual configuration will vary
depending on your cabinet and sink configuration.
NOTE: If installing the internal trap, record the "x" dimension, it will be required in Step 4.
INTERNAL TRAP COMPONENTS SUPPLIED BY OTHERS.
!
PIPING SHOWN ONLY
FOR CLARITY.
PIPING SHOWN ONLY
FOR CLARITY.
Determine Installation Configuration
Figure 1.1A
INTERNAL TRAP
Figure 1.1B
STANDARD (EXTERNAL TRAP)
© Copyright 2017 Zoeller
X (102 mm MIN.)
Co. All rights reserved.
®
4
SEE NOTE
SK2001