2 npt inlet high head drain pump systems (8 pages)
Summary of Contents for Zoeller 1043-006
Page 1
AUTOMATIC SUBMERSIBLE UTILITY PUMP MODEL #1043-0006 Zoeller® is a registered trademark of Zoeller Co. All Rights Reserved. Español p. 9 ATTACH YOUR RECEIPT HERE Purchase Date Serial Number Questions, problems, missing parts? Before returning to your retailer, call our customer...
PACKAGE CONTENTS DESCRIPTION QUANTITY Pump Adapter PERFORMANCE GALLONS PER HOUR AT DISCHARGE HEIGHT ITEM ABOVE PUMPING LEVEL AMPS NUMBER 0 FT. 5 FT. 10 FT. 15 FT. 1043-0006 2100 1800 1320 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate, or install the product.
Page 3
WARNING • ELECTRICAL SHOCK ALERT. Before installing this product, have the electrical circuit checked by an electrician to ensure proper grounding. All electrical installations must conform to the National Electric Code and all local codes. • ELECTRICAL SHOCK ALERT. Connect this product to a properly-grounded 115 volt circuit equipped with a Ground Fault Circuit Interrupter (GFCI) device.
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 5 minutes No Tools Required for Assembly. INSTALLATION INSTRUCTIONS 1.
3. Plug pump into a properly grounded 115V AC power outlet. GFCI Outlet OPERATION 1. The pump will run until it senses that it is no longer pumping water and then shut off. The pump will then turn on every three minutes for fifteen seconds and then off if it does not sense water.
CARE AND MAINTENANCE The motor housing of pump is completely sealed and requires no service. Disassembly of the motor housing or alteration of the power cord voids all warranty. 1. Periodically unplug pump to inspect the inlet and remove any debris. Make sure your hands are Unplug dry and that you are not standing in water.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Pump runs, 1. Hose kinked. 1. Straighten hose. but no water is 2. Defective pump. 2. Replace pump. discharged. 3. Discharge height too great. 3. Reduce discharge height. 4. Clogged inlet. 4. Clean inlet. Motor runs too hot.
WARRANTY This product is warranted for two years from the date of purchase or thirty (30) months from the date of manufacture, whichever occurs first. Subject to the conditions hereinafter set forth, the manufacturer will repair or replace to the original consumer, any portion of the product which proves defective due to defective materials or workmanship.