Table of Contents
Advertisement
ELEMENT LINE: Service & Maintenance Manual - rev. 1.2
5.9. DISASSEMBLING ROLLERS ADJUSTING SYSTEM ON
LAT MACHINE
Figure 5.9-1
Figure 5.9-2
Figure 5.9-3
All manuals and user guides at all-guides.com
On both the rollers:
1. Remove the plastic cap (a).
2. Back off the screw (b) using a 5-mm hex
3. Back off the screws using a 4-mm hex
4. Back off the screw (d) using a 5-mm hex
5. Remove the pin e and the rollers support
wrench and pull the roller out from the side.
wrench on both side and remove the plastic
guard.
wrench, locking down the pin on the
opposite side using a 6-mm hex wrench.
frame (f).
Take care during reassembly procedure
to replace the spacer (g) as shown in the
figure to side.
Continued on next page
→
Page 5.13
Advertisement
Table of Contents
