General Instructions - Burmester 035 Owner's Manual

Operating temperature An operating temperature that is too high or too low may cause malfunctioning. We
therefore recommend letting the 035 sit for a while after unpacking and before connecting
and operating it.
Terminals The pins of the connecting terminals on the back panel should not be touched by fingers
under any circumstances. Static discharges may damage the electronic circuitry inside the
unit.
IR receiver The IR receiver (13) receives signals from the BURMESTER remote control and must not
be covered up by objects.
Heat development Be careful when touching the housing – it may get quite warm during operation.
Reset
If the unit does not react when pressing the control keys on the front it may be reset to
normal operation by switching it off and back on using the AC mains switch in the back.
Lightening strikes During the summer months, malfunctions often occur due to voltage spikes in the power
lines after lightning strikes. Completely unplugging the power cord offers the only effective
protection. Merely switching the 035 off does not suffice since voltage spikes are able to arc
over separated contacts.
Interconnects
We supply custom-made balanced as well as unbalanced interconnect cables and speaker
cables of any length to ensure highest-quality signal paths for our components. The
impedance of our cables is ideally matched to all BURMESTER components.
For the cleanest power supply we recommend our triple-shielded power cord BURMESTER-
POWER.
Fuses The fuses are located inside the unit and should be changed only by a qualified technician.
Voltage
Check before operating the 035 to see if the voltage setting shown on the back panel below
the AC mains input conforms to voltage of your household power supply. Any change
should only be done by an expert.
Warranty We offer warranty for this unit provided the 035 has been hooked-up and operated correctly, is
mechanically undamaged.
Opening the unit, modifying it or dismantling outlets will void the warranty.
Care Never clean the housing with a wet cloth or chemical cleaning agent. Always make sure that no
liquid gets into the housing.
CAUTION Before opening the housing or changing the fuses always unplug the unit from the
wall outlet. DANGER OF ELECTRIC SHOCK!

GENERAL INSTRUCTIONS

11