Burmester 035 Owner's Manual page 9

TAPE output The output terminal OUTPUT TAPE (29) must be connected to the recording input of the
taping device that has been hooked up with its outputs to the 035 INPUT TAPE (30).
The tape out terminal provides the signal of the selected input PHONO, CD, TUNER or AUX
but not the signals from the inputs TAPE and SURROUND.
Volume and tone controls have no bearing on the signal at the TAPE output.
CAUTION: On technical reasons there is no signal at the TAPE output when the volume of
the 035 is set to zero.
Headphones jack The headphones jack PHONES (22) requires headphones with a 6,3mm stereo plug and
an impedance of 100 and more.
Notice: The SETUP menu offers you to choose whether the signal at the PREAMP outputs
will break (HP OFF) while inserting a headphones plug into headphones jack or not (HP
ON).
REMOTE Connecting DC OUT (23) to the corresponding DC IN-jack of another BURMESTER-unit
offers to switch on or off this other unit simultaneous by the 035. In this case, 035 has the
master function.
Connecting DC IN (24) to the corresponding DC OUT-jack of another BURMESTER-unit
offers to switch on or off the 035 simultaneous by the other unit. In this case, 035 has the
slave function.
BURLINK To the BURmester-LINK interface plugs (20), (21) a CRESTRON
connected to the pre amplifier 035. This system allows a comfortable control of your hifi
system using an individual programmable touch panel. With the LEDs beside the plugs
named T and R (Transmit and Receive) you can check whether data exchange is working.
5
®
-System e.g. can be