Table of Contents
Advertisement
Installing Expansion Cards
1. Remove the riser card bracket from the chassis by unscrewing only those screws
inidcated by the screwdriver icon as illustrated in Figure 6-8.
2. Lift the riser card bracket from the chassis.
3. Install the riser card on the bracket using the two screws provided.
4. Open the latch on the end of the bracket.
5. Install the expansion card or GPU by sliding the card into the appropriate slot in
the riser card and then close the bracket latch over the end of it.
6. Install the entire assembly into the appropriate slot on the motherboard while
aligning the bracket in the rear of the chassis.
Important Note for Kepler GPUs: Note the airflow arrow on top of the GPU cards.
Both cards should have this arrow pointing toward the Tesla logo.
Riser Card Bracket
Figure 6-8. Installing the Riser and Expansion Cards in the Bracket
Riser Card
6-9
Chapter 6: Advanced Chassis Setup
1
1
Screwdriver
Icon
1
3
1
4
1
6
Low Profile
Expansion Card
Advertisement
Table of Contents
