Table of Contents
Advertisement
SUPERSERVER 1018GR-T User's Manual
Control Panel Connectors
Power Button
The Power Button connection is
located on pins1 and 2 of JF1.
Momentarily contacting both pins will
power on/off the system. This button
can also be configured to function as
a suspend button (with a setting in the
BIOS - see Chapter 7). To turn off the
power in the suspend mode, press
the button for at least 4 seconds.
Refer to the table on the right for pin
definitions.
Reset Button
The reset button is located on pins
3 and 4 of JF1 and attaches to the
reset switch on the computer chassis.
See the table on the right for pin
definitions.
Power Fail LED
The Power Fail LED connection
is located on pins 5 and 6 of JF1.
Refer to the table on the right for pin
definitions.
20
Ground
x (Key)
Power On LED
HDD LED
NIC1 LED (Link)
NIC2 LED (Link)
UID LED
Power Fail LED
Ground
Ground
2
Figure 5-5. Control Panel Header Pins
5-16
19
NMI
x (Key)
Vcc
Vcc
NIC1 LED (Activity)
NIC2 LED (Activity)
Vcc
3.3V
Reset (Button)
Power (Button)
1
Power Button
Pin Definitions (JF1)
Pin#
Definition
1
Signal
2
+3V Standby
Reset Button
Pin Definitions (JF1)
Pin#
Definition
3
Reset
4
Ground
PWR Fail LED
Pin Definitions (JF1)
Pin#
Definition
5
Vcc
6
Ground
Power Fail LED
Status
State
Definition
Off
Normal
On
Power Failure
Advertisement
Table of Contents
