Table of Contents
Advertisement
SUPERSERVER 1018GR-T User's Manual
System Management Bus
A System Management Bus header
for the IPMI slot is located at JIPMB1.
Connect the appropriate cable here
to use the IPMB I2C connection on
your system.
Power Supply I
The Power Supply I
located at JI2C1, monitors the status
of the power supply, fan and system
temperature. See the table on the right
for pin definitions.
DOM PWR Connector
The Disk-On-Module (DOM) power
connector, located at JSD1/JSD2,
provides 5V (Gen1/Gen) power to
a solid-state DOM storage device
connected to one of the SATA ports.
See the table on the right for pin
definitions.
T-SGPIO1~4 Headers
Three T-SGPIO (Serial-Link General
Purpose Input/Output) headers are
located next to the I-SATA Ports on
the motherboard. These headers
are used to communicate with the
enclosure management chip in the
system. See the table on the right for
pin definitions.
C
2
C Connector,
2
System Management
Pin#
1
2
3
4
PWR Supply (I
Pin#
1
2
3
4
5
DOM PWR (JSD1)
Pin#
1
2
3
Serial Link General-Purpose Headers
Pin Definitions
Pin#
Definition
1
NC
3
Ground
5
Load
7
Clock
5-20
Bus (JIPMB1)
Definition
Data
Ground
Clock
No Connection
C)
2
Pin Definitions
Definition
Clock
Data
PWR Fail
Ground
3.3V
Pin Definitions
Definition
5V
Ground
Ground
(SGPIO)
Pin
Definition
2
NC
4
DATA Out
6
Ground
8
NC
Advertisement
Table of Contents
