Table of Contents
Advertisement
This chapter covers the steps required to install components and perform
maintenance on the chassis. The only tool required is a Phillips screwdriver.
Review the warnings and precautions listed in the manual before setting up or
servicing this chassis. These include information in Chapter 4 and the warnings
and precautions listed in the setup instructions.
Power Supply
GPU Card
Figure 6-1. SC118G Chassis Front and Rear Views
6-1
Static-Sensitive Devices
Electrostatic Discharge (ESD) can damage electronic com ponents. To prevent
damage to any printed circuit boards (PCBs), it is important to handle them very
carefully.
The following measures are generally sufficient to protect your equipment from
ESD damage.
Precautions
•
Use a grounded wrist strap designed to prevent static discharge.
•
Touch a grounded metal object before removing any board from its antistatic bag.
•
Handle a board by its edges only; do not touch its components, peripheral chips,
memory modules or gold contacts.
•
When handling chips or modules, avoid touching their pins.
Chapter 6
Advanced Chassis Setup
Hot-Swap Drive Bays (6)
Rear I/O Ports
6-1
Chapter 6: Advanced Chassis Setup
PCI Slot
Control Panel
GPU Card
Advertisement
Table of Contents
