Table of Contents
Advertisement
Figure 49: BIOS Advanced Menu - Serial Port Console Redirection - COM1 / COM2 Console Redirection Settings
Main
Advanced
COM1
Console Redirection Settings
Terminal Type
Bits per second
Data Bits
Parity
Stop Bits
Flow Control
VT-UTF8 Combo Key Support
Recorder Mode
Resolution 100x31
Putty KeyPad
Feature
Terminal Type
Bits per second
Data Bits
Parity
Stop Bits
Flow Control
VT-UTF8 Combo Key
Support
Recorder Mode
Resolution 100x31
Putty KeyPad
www.kontron.com
BIOS SETUP UTILITY
Power
[ANSI]
[115200]
[8]
[None]
[1]
[None]
[Enabled]
[Disabled]
[Disabled]
[VT100]
Version 2.19.1266. Copyright (C) 2018, American Megatrends, Inc.
Option
Description
[VT100], [VT100+],
Determine the terminal type.
[VT-UTF8], [ANSI]
[9600], [19200],
Select serial port transmission speed. The speed must be
[38400], [57600],
matched on the other side. Long or noisy lines may require
[115200]
lower speeds.
[7], [8]
Determine the data bits.
[None], [Even], [Odd],
A parity bit can be sent with the data bits to detect some
[Mark], [Space]
transmission errors.
[1], [2]
Stop bits indicate the end of a serial data packet (A start bit
indicates the beginning.). The standard setting is 1 stop bit.
Communication with slow devices may require more than 1 stop
bit.
[None], [Hardware
Flow control can prevent data loss from buffer overflow. When
RTS/CTS]
sending data, if the receiving buffers are full, a 'stop' signal can
be sent to stop the data flow. You may select "None" or
"Hardware RTS/CTS" depending on the circumstances.
[Disabled], [Enabled]
Select whether to enable or disable VT-UTF8 Combination Key
Support for ANSI/VT100 terminals.
[Disabled], [Enabled]
Select whether to enable or disable recorder mode. With this
mode enabled, only text will be sent. This is to capture terminal
data.
[Disabled], [Enabled]
Select whether to enable or disable extended terminal
resolution.
[VT100], [LINUX],
Select FunctionKey and KeyPad on Putty.
[XTERMR6], [SCO],
[ESCN], [VT400]
mITX-DNV - User Guide, Rev. 1.0
Boot
Security
→ ←: Select Screen
↑ ↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Save & Exit
// 74
Advertisement
Table of Contents
