Manual Adjustment By Touching The Screen - FLIR T530 User Manual

14 Achieving a good image
analysis difficult. You can analyze the building in more detail if you change the temperature
scale to values close to the temperature of the building.
Automatic
14.3.1.2 Example 2
Here are two infrared images of an isolator in a power line. To make it easier to analyze
the temperature variations in the isolator, the temperature scale in the right image has
been changed to values close to the temperature of the isolator.
Automatic

14.3.2 Manual adjustment by touching the screen

14.3.2.1 Procedure
Follow this procedure:
1. In live mode, touch the soft button
2. To simultaneously change the temperature scale minimum and maximum limits, place
your finger on the screen and move it up/down.
3. To change the minimum limit or the maximum limit, do the following:
• Touch the maximum or minimum temperature that you want to change.
• Place your finger on the screen and move it up/down to change the value of the
highlighted temperature.
14.3.2.2 Auto-adjusting the image in manual mode
In manual image adjustment mode, you can auto-adjust the image by touching the screen.
The image will be auto-adjusted based on the thermal content of the area around the
touched point. The top and bottom levels in the temperature scale will be set to the
#T810253; r. AA/42549/42549; en-US
Manual
Manual
to enter manual image adjustment mode.
57