Laser Transmitter And Receiver; Difference In Position - FLIR T530 User Manual

8 Camera parts
Note
• The laser is enabled by a setting. Select
ser > Enable lamp & laser.
• The symbol is displayed on the screen when the laser is on.
• The camera can be configured to automatically measure the distance when an image
is saved. Select (Settings) > Save options & storage > Measure distance. With this
setting, the Object distance parameter (see section 16.5 Changing the measurement
parameters, page 70) in the image data is automatically updated with the measured
distance when an image is saved. (There is no effect on the Object distance setting in
live mode.)
• If the target reflection is low or if the target is angled from the laser beam, there may be
no return signal, and the distance cannot be measured.
• The laser distance meter may not be enabled in all markets.

8.4.2 Laser transmitter and receiver

1. Laser receiver.
2. Laser transmitter.

8.4.3 Difference in position

This figure shows the difference in position between the laser transmitter and the optical
center of the infrared lens. The laser transmitter and the optical axis are parallel.
#T810253; r. AA/42549/42549; en-US
(Settings) > Device settings > Lamp & la-
21