11
Handling the camera
The focus method is configured by a setting. Select
cus > Auto focus and then select Contrast or Laser.
11.6.2 Figure
11.6.3 Procedure
WARNING
When the camera is set to autofocusing with the laser method (Settings > Device settings > Focus > Auto
focus >Laser), do not point the camera at the face of a person when you use the autofocus function. The
laser beam can cause eye irritation.
Follow this procedure:
1. To autofocus the infrared camera, push the Autofocus button.
Note You can also assign the autofocus function to one of the programmable buttons
For more information, see section 11.12 Assigning functions to the programmable buttons,
page 37.
11.7 Continuous autofocus
11.7.1 General
The infrared camera can be set up to perform continuous autofocusing.
When the continuous autofocus function is enabled, the camera bases the focus adjust-
ments on continuous laser distance measurements. The laser is continuously on.
WARNING
Do not point the camera at the face of a person when the continuous autofocus function is on. The cam-
era uses laser distance measurements (that are continuous) for the focus adjustments. The laser beam
can cause eye irritation.
#T810253; r. AA/42549/42549; en-US
(Settings) > Device settings > Fo-
.
33