Table of Contents
Advertisement
11
Handling the camera
2. Set the camera to measure and display the area of the box or circle, see section 16.6
Displaying values in the result table, page 73.
3. Make sure that the box or circle tool is in the center of the image, see section 16.4
Moving and resizing a measurement tool, page 69.
4. Adjust the size of the box or circle tool to the size of the target, see section 16.4 Moving
and resizing a measurement tool, page 69.
5. Hold the camera perpendicular to the target. Push and hold the laser button
6. The calculated area is displayed in the result table.
11.10 Connecting external devices and storage
media
11.10.1 General
You can connect the following external devices and media to the camera:
• An SD memory card.
• A computer to move image and video files to and from the camera, using a USB-C to
USB-A or a USB-C to USB-C cable.
• A video monitor or projector, using a USB-C to HDMI adapter.
• A USB battery charger.
Note Empty or use a memory card that has not previously been used in another type of
camera. The cameras may organize files differently on the memory card. There is there-
fore a risk of losing data if the same memory card is used in different types of cameras.
11.10.2 Figure
11.10.3 Explanation
1. USB-C cable.
2. SD memory card.
3. LED indicator showing that the memory card is busy.
Note
• Do not eject the memory card when this LED is flashing.
• Do not connect the camera to a computer when this LED is flashing.
Note When closing the cover for the connector compartment, firmly press along the
edges of the cover to make sure that it closes tightly.
#T810253; r. AA/42549/42549; en-US
.
36
Advertisement
Table of Contents
