Locking The User Interface; Updating The Fixture Software - ETC ColorSource Linear Installation Manual

ETC Installation Guide
ColorSource Linear v1.5

Locking the user interface

After you have set up the fixture, you can lock the user interface to prevent
additional changes.
1: Hold the Up and Down buttons simultaneously for 3 seconds. The
display will show
2: To unlock the user interface, hold the Up and Down buttons
simultaneously for 3 seconds.

Updating the fixture software

ETC recommends using UpdaterAtor software to manage software updates.
For more information on UpdaterAtor, see the
Guide
, which you can download for free from etcconnect.com.
When you add a ColorSource fixture running a newer software version or
update a ColorSource fixture to a newer software version using UpdaterAtor,
you can use that fixture to push the newer software version to all connected
ColorSource fixtures.
You can push newer software versions from a connected fixture only on
ColorSource fixtures running software v1.3.0 or newer. Use UpdaterAtor to
update individual fixtures running versions older than v1.3.0.
1: Remove power and DMX from the master fixture that is running the
software version that you want to push to other fixtures.
2: Hold the Up and Down buttons simultaneously while restoring power.
3: The display will show
selected.
4: Press the Mode button to start the update process.
• The display will alternate between
• The master fixture will reboot once the update is complete.
ColorSource Linear v1.5

complete while updating.
to indicate that the user interface is locked.

to indicate the update mode is

Page 13 of 16
UpdaterAtor Software Quick
and the percentage
ETC