Customer Calibration; 6.2.1 Enabling Customer Calibration - Mahr Millimar C 1200 Operating Instructions Manual

If a customer-specific calibration is required, this can be completed in the
menus described in the following. The calibration can be completed with the
connected probe or alternatively with a factory standard (e.g. Mahr 1283 WN
Factory Calibration, Order no. 5312833).
6.2

Customer calibration

6.2.1 Enabling customer calibration

– Press the ON / OFF key
=> Standard menu appears
– Press u to select the System
menu
– Press q to select the Customer
calibration submenu
ü
– Press to confirm
– Press q to select the Enable
submenu
ü
– Press to confirm or Ó
cancel the selection
ü
=> The symbol indicates the
currently active calibration
– Press the ON / OFF key to exit the
input menu.
36
to
Measurement Display Setup
Absolute mode
Customer calibration
Factory calibration
Factory settings
Keyboard-/ menu interlock
Info
ü
Ó
Measurement Display Setup
Customer calibration
Enable
Probe calibration
Factory standard calibration
Customer calibration Reset
ü
Ó
Measurement Display Setup
Absolute mode
Customer calibration
Factory calibration
Factory settings
Keyboard-/ menu interlock
Info
ü
Ó
Mahr GmbH • Millimar C1200
System
ü
q p
System
q p
System
ü
q p