Mahr Millimar C 1200 Operating Instructions Manual page 38

Enter value for Calibration Max
–
(e.g. +1.000 mm). Press u
select the required position and
press q p to enter the required
value.
ü
– Press to confirm or Ó
the selection
– Move the Probe to the Min
position (e.g. measuring plate)
=> The following appears on the
display:
Set probe to Calibration Min and
accept
ü
– Press to confirm
– Move the probe to the Max
position (e.g. 2.000 mm gauge
block)
=> The following appears on the
display:
Set probe to Calibration Max and
accept
ü
– Press to confirm
=> Probe calibration according to
the customer's specification is
complete and activated.
– Press the ON / OFF key to exit the
input menu.
38
to
to cancel
Measurement Display Setup
Customer calibration
+ 0 0 1 . 0 0 0
Calibration Min Nominal value
-1.000 -0
ü
u
Ó
Measurement Display Setup
Customer calibration
Calibration
Min
and accept
Calibration Min Nominal value
-1.000 -0
ü
3 Ó
Display Setup
Measurement
Customer calibration
Calibration
Max
and accept
Calibration Min Nominal value
-1.000 -0
ü
3 Ó
Measurement Display Setup
Absolute mode
Customer calibration
Factory calibration
Factory settings
Keyboard-/ menu interlock
Info
ü
Ó
Mahr GmbH • Millimar C1200
System
Calibration Max
1.000
q p
System
Calibration Max
1.000
q p
System
Calibration Max
1.000
q p
System
ü
q p