Extra configuration
Fault settings DHW
Note
DHW operating mode
Building Technologies
HVAC Products
The output is to be activated via "Extra configuration":
Main menu >
Commissioning > Extra configuration > DHW > Outputs > Mixing valve 3-
pos
Assign terminal
Main menu >
Commissioning > Extra configuration > DHW > Outputs > Mixing valve
modulating
Assign terminal
10.2.4 Pump control
All DHW pumps offer the same choices as any other pump in the controller. Supervi-
sion is also possible for an individual pump; optionally, every DHW pump can be a twin
pump. For that, the respective outputs must be configured.
For more detailed information, refer to section 5.8 "Pump control and twin pumps".
Main menu > Commissioning > Settings > ... or
Main menu > Settings > DHW > Fault settings > Overload primary pump
Main menu > Settings > DHW > Fault settings > Overload secondary pump
Main menu > Settings > DHW > Fault settings > Overload circulating pump
Operating line
Fault acknowledgement
Fault acknowledgement B
10.3
Operating modes and setpoints
10.3.1 DHW operating modes
The DHW operating mode defines the setpoint at which the storage tank or the flow
temperature is maintained.
Consumer control (optional) has a direct impact on the DHW temperature in the con-
sumer network. As a result, the settings made here will probably not be noticed by the
DHW consumer, or only with a certain delay.
Main menu > DHW > DHW optg mode
Operating line
Preselection
State
Cause
Modular Heating Controller RMH760B
10 DHW heating
Range
None / Acknowledge /
Acknowledge and reset
None / Acknowledge /
Acknowledge and reset
Range
Auto /
Normal /
Reduced /
Protection /
Normal /
Reduced /
Protection /
DHW time switch
/
Holidays
or
/
Special day
or
/
DHW operation selector
DHW operating mode
contact
/
Forc charg contact
/
Legionella program
/
Electric
Factory setting
Acknowledge
and reset
Acknowledge
and reset
Factory setting
Auto
/
151/238
CE1P3133en
05.02.2007