Ribbon Saving Module Selection - TEC B-680 SERIES Maintenance Manual

6. DIAG. TEST OPERATION

6.3.16 Ribbon Saving Module Selection

< 1 >
D I A G N O S T I C
< 2 >
P A R A M E T E R
Press the [PAUSE] key 17 times.
R I B
B O N
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a fast
forward.
2. A changed data length is stored in memory by pressing the [PAUSE] key.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
S A V E
Select ribbon saving module
with the [FEED] key or
[RESTART] key. (See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
1 . 0 A
V
S E T
O N
OFF: The ribbon saving module is not used.
ON: The ribbon saving module is used.
Press the [PAUSE] key.
Continued on Section 6.3.17
Control Code
6-37
6.3 PARAMETER SETTING MODE
Selection.
EO18-33006